If all files exist that are mentioned in the previous section you can load the environment that you want to work with by pressing the hotkey E and entering the pathname or with the command:
tv cut environment /matrix1/220Th
TV loads the environment to the buffers that are by default set to the values listed in table 5.3. Using the commands from chapter 5.2 one can define more than one environment and perform cuts in several matrices simultaneously.
Buffer type | Default |
Cut | |
Matrix | |
Projection | 15 |
Spectrum |
The single commands executed by the cut environment command are:
tv cut matrix open /matrix1/220Th/220Th.mtx
tv spectrum read /matrix1/220Th/220Th.pry
tv cut directory open /matrix1/220Th/220Th.cutdir